INTRODUCTION... Thank you for purchasing the Pyle MARINE Class-D amplifier. Rest assured you have purchased a quality product designed and engineered to give you many years of uncompromised musical service.The Pyle MARINE Class-D amplifier has been designed using the latest in electronic technology available today. This is due to the noise introduced into the signal by the switching speed of the power supply, which must be filtered out of the audio signal.
general features PLMRA1000D 2000W Mono Block MOSFET Digital Power Amplifier · Mono Block Subwoofer Amplifier · 1 Ohm Stable · MOSFET Power Supply · PWM (Pulse-Width-Modulation) System · Glass Epoxy PCB · Gold Plated RCA Inputs for Line Input & Bypass Output. · Gold Plated Terminals for Speaker Output and Power Input.
fC lea sas t- Du Mr OeN Os B LaO nC Kd A McP oL InF ItE rR oP LlMsR A 1 0 0 0 D PLMRA1000D Mono channel amplifier Class-D design power supplies crossover low pass filter high pass subsonic filter output power @14.4v DC,50KHz RMS Power at @4 Ohms Stiffly regulated PWM power supplies. MOSFET switches maintain RMS Power at @2 Ohms rated power over a wide range of battery voltages. RMS Power at @1.3 Ohms Adjustable from 20Hz to 250Hz with a slope of 24dB per octave.
system wiring Class-D MONO BLOCK AMPLIFIER PLMRA1000D POWER INPUT CONNECTION PLMRA1000D 6 amplifier and installation mounting Find a suitable location in the vehicle to mount the amplifier Make sure there is sufficient air flow around the intended mounting location wiring tips Bolt the amplifier to the mounting surface. Connect the power ground terminal to the nearest point on the chassis of the car. Keep this ground wire less than one meter (39") in length. Use 4 gauge wire.
troubleshooting Before removing your amplifier, refer to the list below and follow the suggested procedures. Always test the speaker and their wires first. Amplifier will not power up Check for good ground connection. Check that remote DC terminal has at least 13.8V DC. Check that there is battery power on the terminal. Check all fuses. Check that Protection LED is not lit. If it is lit, shut off amplifier briefly and then repower it. High hiss or engine noise(alternator whine) in speakers.
