Cassette Player User Manual

6
RECORDING INSTRUCTIONS
Please use deck B for recording external sources or
dubbing tapes.
RECORDING EXTERNAL SOURCE TO TAPE:
1. Press [STOP/EJECT] on deck B to open the cassette
holder.
2. Insert a blank tape and close the cassette holder.
3. If recording to a Cr02 tape, press the [REC Cr02]
button.
4. Press the [PAUSE] button and then press
[RECORD].
5. Play your external source and check the levels on
the display. Use the REC LEVEL knob to adjust the
level of the incoming audio signal.
6. Press the [PAUSE] button to begin recording when
you are ready.
Tip: The REC LEVEL knob can be used to make
adjustments to the loudness of the incoming signal. If
the knob is in the center position, the incoming signal
will be recorded at its original volume. Ideally, the
recording signal should come close but never hit red in
the level indicator on the display. If the signal is in the
red, then turn down the REC LEVEL knob until it no
longer reaches the red. If the signal is too low and not
close to the red, turn up the REC LEVEL knob.
DUBBING OPERATION:
1. Insert the tape for playback in deck A.
2. Insert the tape you wish to record to in deck B.
3. Press the [DUBBING] button. “Dubbing” will be
illuminated on the display.
4. Select the dubbing speed with the [HI SP DUB]
button. If the “HI SP DUB” indicator is
illuminated on the display, you will be dubbing in
high-speed mode. If the indicator is not lit, then you
will be recording in normal-speed mode.
5. Press the [PAUSE] button on deck A, followed by
the [PLAY] button to cue the tape.
6. Press the [RECORD] button on deck B.
7. Press the [PAUSE] button on deck A to release pause
mode. The unit will automatically start the dubbing
operation.
8. To stop dubbing, press the [STOP/EJECT] button of
deck B.
Please note: Do not change dubbing speed while
dubbing is in progress.
TECHNICAL SPECIFICATIONS
Type Stereo double cassette deck
Track System 4-track 2-channel
Tape speed 4.8 cm/sec
Frequency Response
(-20dB recording)
Chrome tape 40-15000Hz
(±3dB)
Normal tape 40-14000Hz
(±3dB)
(0dB recording)
Chrome tape 40-8000Hz
(±3dB)
Normal tape 40-8000Hz
(±3dB)
S/N ratio 58dB
Wow and flutter <0.2% (DIN45500)
Crosstalk 40dB (1kHz)
Harmonic distortion less than 1% (at 1 kHz,
OVU 3
rd
H.D. normal tape)
Channel separation 40dB (1kHz)
Head
Deck A Playback
Deck B
Recording/playback,
2-gap ferrite head for
erasure
Motor DC servo motor x 2
Fast forward/Rewind time ~100 sec w. C-60 cassette
Input terminals
Line In x 2 Min. input
level: 600mV (0dB)
Input impedance: 50k.
Output terminals
Line Out x 2 Output level:
600mV (0dB)
Output impedance: 5k.
Power requirement AC 110V ~ 60Hz
Power Consumption 6W Maximum
Dimensions 420mm x 135mm x
215mm (W x H x D)
/ 16.54” x 5.32” x 8.46”
inches)
Weight 4kg (8.5lbs)