User's Manual

E. Workout Mode - GPS
E- 02
Workout mode
Hold
[H]
Fixing with
GPS
GPS Fixed
How to turn ON the GPS manually:
If GPS receiver has been stopped for a long time, say more than 2
hours, it is recommended to start the GPS manually, especially
when you want to have track logging done at the beginning of
workout. It is because the GPS cold start time is long. Usually it
takes approximate half a minute. During the cold start period, track
information is not available. you should have the GPS position
updated beforehand. To do this you can do either of the followings:
a) Menu> GPS> GPS ON or OFF (turn GPS ON); or Simply hold
[V] for 2 seconds at Workout / Navigation modes to toggle GPS
either ON or OFF.
b) Menu> GPS> Timeout
It can be chosen either 5 or 30 minutes. If GPS is lost and 30
minutes timeout is selected, the watch will try re-locate it position
via satellites in 30 minutes.
GPS status indicator
- When GPS is collecting satellite information, an “ANTENNA”
icon is flashing at the top right for most of the workout views.
- If GPS has a 2D location located, “GPS fixed” message will pop-
up and it will last for a few seconds. Icon at the top left is as
shown here.
- If more satellites are captured, GPS has a 3D location located.
Icon will be like this.
- If GPS loses contact with satellites and cannot fix its position,
GPS “GPS Lost” pop- up message will appear. It stays on the
LCD until any of the button is pressed.