Instruction Manual
Maximum Sp
ee
d
Press the C button in the pedometer mode until MAX SPEED
is displayed,
The maximum speed is shown in the low
er
segment
of
the
display, in the middle the current speed.
Maximum Speed
-
-
.. "
:Ii
n.D~
+ U
Km/h
X:
sa
;~
n.D~
+
UKm
/h
fiX
:
O!l
K
eep
the A button pressed - the display RESET appears -
reset the maximum speed to zero.
DISPLAY LIGHT
The display is illuminated for about 2 seconds by pressing the
B button, so you can read the display of the heart
ra
te
monitor watch in darkness. A permanent illumination of the
display is not possible. Please note that the illumination
consumes more
power
,
wh
ich reduces the lifespan
of
the
battery,
TROUBLESHOOTING
Why is the displayed covered distance incorrect?
Have you performed a calibration? For optimum results the
calibration h
as
to be performed for ''walking'' as well as
"running".
A shuffling gait, bad shoes and varying surface can
lead to inaccurate measurements.
A lower distance is
measured when climbing steps, because the watch is
designed for even surfaces. Choose the used during
calibration speed when walking
or
runni
ng.
Please note that
t
he
measurements
of
untrained persons can
be
inaccurate/irregular.
Why does the heart rate
monitor
watch
not
display
the
heart rate?
Pl
ease
ched<.
t
he
chest belt. Possible causes of err
or
are
:
• The chest belt is
no
t positioned correctly.
• The skin is too cold
or
dry.
• The sensor contacts are not moistened
or
are
dirty.
• Atmospheric
or
wireless interferences appear
due
to for
example high voltage lines
(a
bove
or
below ground),
overhead electrical lines, electric molars. car engines.
mobile phones, airplanes etc.
•
VVeak
battery in the chest belt - please change.
• Distance to the chest belt is too large (max.
60
em
).
• Signa
ts
from other chest belts in the surrounding
of
less
than 2 metres can
be
the cause
of
incorrect values.
The
display
of
the heart rate is incorrect,
why
?
• Perhaps the sensor contacts of the chest belt are not
moistened.
• Check if the chest belt fits tightly to the chest.
• Also check the battery
•
We
advise
againslthe
simu
lt
aneous use of the heart rate
monitor watch and a wireless bicycle computer, because the
signals from t
he
transmi
tt
er
of
the bicycle computer can
interfere with the heart rale monitor watch.
• Signals from other chest belts in the surrounding
of
less
than 2
me
tres can
be
the cause
of
incorrect values.