Printer User Manual
Part 19
to host whenever an off line status occurs. Therefore, signals including the 
paper near end detect will generate busy signal to the host. Consequently, the 
printing may be stopped even when there is still a long way to go before the 
paper roll is actually exhausted. Taking the paper out beep into consideration, 
the printer will keep on beeping at Paper End (completely no paper) till paper 
is replaced when S1-5 is ON. Yet when S1-5 is OFF, the printer will keep on 
beeping every 3 seconds at Paper Near End (still long paper in replace) till 
paper is replaced. 
For switch position 6, when it is set to OFF, there will be a 20 mm paper 
feed before cutting when software does not define this point and there will be 
further 10 mm paper after cutting to prevent paper jam. Before setting this 
switch to ON, please make sure that your software will take care of enough 
paper feed for the paper jam prevention issue. 
For switch position 8, when it is set to ON in the field, the printer maybe 
subject to unpredictable damages and must be strictly prevented. 
The factory default for each position is listed below: 
Switch Position  1  2  3  4  5  6  7  8 
Serial interface w/ 
auto cutter 
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Parallel interface w/ 
auto cutter 
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
USB interface w/ auto 
cutter 
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
LAN
 interface w/ auto 
cutter 
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
INTERNAL SWITCH 
There is an extra internal 4 position DIP switch in PP-7000II series  for 
more technical settings. To access these setup, please first turn off the printer 
power and disconnect every cable from the printer. Remove 4 screws from 
bottom of printer and remove the plastic bottom cover with the power switch 
pressed. The 4 position DIP switch seats beside the 8 position DIP switch for 
setup window with the switch position counting starts from the nearest side to 
the 8 position DIP switch. 
This 4 position DIP switch works as following: 
Switch position  Setting Effect 
ê
Function  ON  OFF 
1
Factory internal setting
Disable  Default 
2
Paper width  58 mm  80 mm 
3
Line format  576 dots / line  512 dots / line 
4
Reserved  N. A.  N. A. 










