User's Manual

4.AUTO FULL SCAN
PRESS ENTER TO START
↑↓ADJUST
EXIT:SETUP OK:ENTER
AUTO FULL SCAN
When the indicator is on the AUTO FULL SCAN, press ENTER
on the unit/remote to display this picture and auto full scan
channels by pressing ENTER
5.MANUAL SCAN
↑↓ADJUST
EXIT:SETUP OK:ENTER
MANUAL SCAN
When the indicator is on the MANUAL SCAN, press ENTER on
the unit/remote to display this picture and auto full scan
channels by pressing ENTER
6.FINE TUNE
↑↓ADJUST
EXIT:SETUP OK:ENTER
FINE TUNE
When the indicator is on the FINE TUNE, press ENTER on the
unit/remote to display this picture and fine tune by CH+/CH-
《1 7》
Setting Up The Dome Lamps
*Operating the dome Lamps
1. There are three function buttons for the Dome lamps operation: OFF,
DOOR, and ON. (Refer to the following figure)
A. OFF: To turn off the lamps.
B. DOOR: To make the lamps turned on
only when car doors are
opened.
C. ON: To turn on the lamps.
* The electric circuit figure
Point
Power Cord Color
Connection
R
W
B
Red
White
Black
Connecting With Power Supply
Connecting With Sensor of Car Doors
For Ground Connection
* Remarks:
1. There would be no any power cord puling out from "B" point as
"B" have been connected with a ground connection by screws.
2. Power supply should be used in 12 Voltages.
WW
BB
OFFOFF
DOORDOOR
ONON
LAMPSLAMPS
RR
BATTERY +BATTERY +
《6》