User's Manual

Controls, Input and Output Cables:

The switches and gain settings are located behind a watertight pulg, which

also lights up when the amplifier is on. Be sure to replace the plug when

finished with adjustments

The INPUT LEVEL switch selects the input sensitivity of the amplifier. If

you are connecting to a LINE level source (typically any RCA type

connection) then the switch should be in the LINE (out) position. When

connecting to loudspeaker outputs or headphone or high level sources

then set the switch to the SPEAKER (in) position.

The POLARITY switch allows the user to optimize bass performance in

the case that there are more than 1 set of loudspeakers producing bass

in the system. Play some music with strong bass content and listen with

the switch alternately in the NORMAL and REVERSE position until it can

be determined which setting results in more pleasing bass response. If

in doubt, or if any interaction with other speakers is unlikely, then leave

the switch in the NORMAL position.

The GAIN control adjusts the overall level of the amplifier. When using

the amplifier without volume control the level should beset to achieve a

balance with other loudspeakers in the system. As arule, keep the gain

setting as low as possible while still insuring that thesystem will reach

full output power. When using the system with external volume control,

set the external Volume Control to FULL (clockwise) and adjust the gain

on the amplifier until full output power is reached. Full output power level

can be determined by turning the gain control clockwise until the apparent

loudness does not appear to increase any more. Leave the control at the

setting where this begins to become apparent.

dB GAIN

MIN

MAX