PLCDUSMP74 R OWNER C A R A U D I S MANUAL O S Y S T E M A M / F M T U N E R C D / M P 3 P L A Y E R
Seek Play/Pause Scan Repeat Shuffle Radio wiring Speaker wiring Install the unit Removing the unit USB PLAYER AUX IN Power Volume Eject Release Mode Loud Clock EQ Band Loc Tune St Loading and Replacing the battery Basic operation Volume setting Bass setting Treble settting Balance setting Fader setting 1
To prevent injur y or fire,take the following precautions: Insert the unit until it is firmly locked to the main unit, otherwise it may fall out of place when jolted When extending the ignition, memory back up or ground cable, use diameter of 0.75mm(AWG18) or more automotive grade cable to avoid wire deterioration or damage to the wire coating. To prevent short circuit, never put or leave any metallic object into the unit. If you smell or see smoke, turn off the power immediately and consult your dealer.
Follow this easy wiring diagram in order to enable you to install the new or existing RADIO and SPEAKER wring system. Be sure the unit is connected to a 12 volts battery with negative ground. Good ground connections eliminate most electrical noise problem and require tight with the metal vehicle chassis.remove plastic, paint or dust for good electrical contact.
B efore installing the receiver permanently, fit it in the approximate place in your car Connect the equipment according to the speakers and electrical connections. When your system is operated properly,(preferably with the car engine running), follow the instructions for permanent installation of your system. 3)Support strap (supplied) INSTALL THE UNIT 1)Install half sleeve, can be with or without adapter. It will fit better with adapter.
Volume/Push sel SEL/VOL EJECT Increasing volume SEEK BAND L AUX IN EQ EQ CLOCK E C SCAN 1 2 REPEAT 3 SHUFFLE 10- 10+ 4 5 6 CLOCK LVO VOL MODE VOL LOC Rotate the [VOL-]button BD ST S L+ PUSH SEL Decreasing PUSH SEL VO Rotate the [VOL+]button EJECT E MD POWER LOUD LD P POWER LOUD Eject Out LOC ST LOUD Press the [EJECT]button to eject the disc out of the unit . CH LCD display EJECT Power Tur ning ON the power Press the [PWR]button.
Hour MODE Rotate [VOL+/-]button to adjust the hour. Minute When CD disc in unit ,press [MODE],it will switch between: BAND CD USB AUX IN Press [SEL] then Rotate [VOL+/-] button to adjust the minute. BAND Quit clock set mode No CD disc in ,press [MODE],it will switch between: BAND USB AUX IN If there is no operation in 5 seconds, it will quit clock set mode. BAND EQ DSP EQ setup LOUD DSP LOUD Press EQ button once to enter ROCK volume,LCD shows EQ and ROCK on.
SEL/VOL Speaker mode VOLUME TREBLE BASS EJECT E PUSH SEL SEEK ST S FADER BALANCE VOL LOC L AUX IN EQ CLOCK E C SCAN 1 In press mode, VOL is sel function 2 REPEAT 3 SHUFFLE 10- 10+ POWER 4 5 6 P SCAN REPEAT Volume set mode L- LOUD LD SHUFFLE Treble set mode L+ VO BD MD Press SEL button third, display shows TRE ,then rotate the volume + button to adjust treble level up. Rotate the volume - button to adjust treble level down.
/ Repeat If CD in unit, press[ ] to select tracks, and long / press to fast advance and back. Press [RPT]button Play/pause Shuffle REPEAT Press [REPEAT] button first to repeat the playing track continuously. Press second to repeat the whole disc. Press third back to normal playing. Pause If with DISC in unit,Press the [ Press [SHUFFLE]button ]to pause music. Press [SHUFFLE] button to play all the track in random order. SHF and playing song number will appear on the LCD.
USB 10-,10+: under USB playing,press 10- 10+can make selection from No.10 tracks, for example: if you want select No.15 song,press 10+to skip to No.10,and then press to select No.5 from No.10 EJECT E PUSH SEL SEEK ST S VOL LOC L AUX IN EQ CLOCK E C SCAN 1 2 REPEAT 3 SHUFFLE 10- 10+ POWER 4 5 6 P BAND Note:Under USB playing station,cannot put in or out CD DISC. Note BD MODE MD LOUD LD AUX in AUX IN Insert AUX in,then press[MODE] to transfer to AUX IN play.
SEEK+ SEEK- BAND Tune In radio mode: manual tuning: EJECT E PUSH SEL SEEK ST S VOL LOC L AUX IN EQ CLOCK E C SCAN 1 2 REPEAT 3 SHUFFLE 10- 4 5 10+ 6 POWER P short press Short press BAND BD MODE MD Auto loading tuning: LOUD LD the long press button it can automatically select higher frequency station. And long press can automatically select lower frequency station. LOC MONO Band ST Selecting band In FM band mode,press the ST key.
Loading and replacing the batter y POWER MUTE Use one lithium battery(CR2025) insert the batteries with the +and - poles aligned properly. Following the illustration inside the case. PLAY/PAUSE EQ 1 2 3 4 5 6 7 8 9 10/0 10+ APS ST BND LOD SEL CLK RPT SCN Pull out Store unused batteries out of the reach of children. Contact a doctor immediately if the battery is accidentally swallowed. Do not set the remote on hot places such as above the dashboard.
Volume Exter nal view ........ Number of items Exter nal view ........ Number of items Increasing volume Turn the [+]knob clockwise. Increasing volume 1 ............ 1 6 ............ 1 2 ............ 1 7 ............2 3 ............ 1 8 ............2 4 ............ 1 9 ............1 5 ............ 1 10 ............2 Turn the [-]knob counter clockwise Play/pause Play Press the [ ]button Pause Press again the [ ] button Other function Please refer to panel.
Specifications subject to change without notice. CD PLAYER GENERAL Signal/Noise radio......................................................70dB Frequency response..............................20Hz-20KHz(+3dB) Channel separation..................................................>45dB Dual D/A converter.......................................................16Bit Operating power.....................................12 Volts DC,negative ground %10THD output wiring.........................
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. ?No/Poor sound on one or more speakers Speakers or speaker wiring or volume, Balance and Fader setting Check the speaker wiring and test the speakers all in good condition check the setting of volume, Balance and Fader controls. ?The power does not tur n ON. The fuse has blown.
C a r A u d A i M o / H F M i T f U N i E S R y s t e m
