Operating Guide

-3-

1. Remove the chassis from Slide Bracket Housing;

1) Press the REL button to release the control panel ;

2) Hold the right side of the control panel to pull it upwards a little and then to you

for removing it ;

3) Remove the PLASTIC FRAME

from the chassis (see the Installation diagram);

4) Insert the 2 KEY PLATES into the grooves at the both sides of the chassis till

they click(see the Installation diagram);

5) Pulling the two KEY PLATES to remove the chassis from the Slide Bracket

Housing ;

2. Mount the Sliding Bracket Housing in the position of car multi-media system and

bend some tabs of Sliding Bracket Housing to fix it.

3. Connecting all wires:

1) Connecting all wires according ot the wiring diagram on next page;

INSTALLATION STEPS

REL button