Operating Guide

Operation of GPS module
1. GPS Navigation
1. Loading GPS card
Before setting GPS path and entering GPS navigation mode, must load a GPS
card with navigation map program file into the GPS card slot.
firstly press REL button to detach control panel, then hold the right part of the
control panel and pull upwards a little and to you to remove it, and then insert
the GPS card with label side upward and contact end frontward into the GPS
card slot as the following fig., and then attach control panel onto chassis
again.
2. Setting GPS path
After loading GPS card and before entering GPS navigation mode, must set
the GPS path to an executale navigation map program file.
Touch SYSTEM icon on the setup page of the source menu to pop up page1 of
SETTINGS MENU, then touch the item of GPS PATH SETTING to pop up GPS
PATH interface as follows:
Label side
facing upward
: to enter the card in the GPS card slot and select a desired executable navigation map program
file(generally the extension name of an executable navigation map program file is exe) .
: If touching the white rectangle for ticking it, it will enter GPS mode automatically after
resetting the unit or switching the ignition off and then power on the unit again.
: If touching the white rectangle for ticking it, when GPS and another work source of
radio, disc, USB, card, AUX or BT are working at the same time, the audio of
radio,
disc, USB, card, AUX or BT music and the navigation voice are available. When out-
putting navigation voice, the audio of radio, disc, USB, card,
AUX or BT music is mute;
when no outputting navigation voice, the audio of radio, disc, USB, card, AUX or BT
music is available. If no
ticking it, the navigation voice is mute when GPS and another
work source are working at the same time.
: to exit to the page1 of SETTINGS MENU.
GPS PATH
-40-