Clock Radio User Manual

LOCATION OF CONTROLS
1 IPod/iPhone Connector 11 PLAY/PAUSE [/ ] / MEM Button
2 Display 12 Volume+ Button
3 Speaker 13 Snooze / Sleep Button
4 Skip Down [
 ] / Tun- Button 14 Volume- Button
5 Alarm 1 Button 15 Battery Compartment
6 Function/Clock Adjust Button 16 FM Antenna
7 Power/Alarm Off Button 17 DC In Jack
8 Skip Up
[  ] / Tune+ Button
9 Alarm2 Button
10 Color Button
- 4 -
CONNECTING THE UNIT TO POWER
Plug one end of the AC/DC adaptor into the DC-In jack, and then plug the other end into AC wall outlet.
Before switching on the unit, make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
Back-up Battery
 Open the battery door located at the bottom of the unit, insert 2 pcs. ‘AA’ size (UM-3) batteries with
battery polarities same as shown inside the battery compartment.
 In case of AC power outage or interrupted AC power, the current time, alarm time settings and the
stored radio stations are preserved in the memory of the unit.
Important: When the unit is not use for 3 days or more and also the unit is not connect to AC power
during that time, please remove the battery to avoid damage to the set from leakage of battery.
SETTING THE TIME
Before starting to set the time, make sure that the unit is in POWER OFF Mode.
If you have IPhone or iPod (Except iPod Shuffle)
1. Dock in the iPhone/iPod on the 30 pins Connector
2. Press the SNOOZE/SLEEP button for a few seconds until the display shows SYN, and the unit is
automatically synchronized the time same as the iPod/iPhone.
If you do not have any iPhone/iPod units
1. Press and hold the FUNC/CL ADJ button for a few seconds, the hour digit in the display will start
flashing.
2. Press the SKIP UP/TUNE+ or SKIP DOWN/TUNE- button to adjust the hour.
3. When the correct hour is selected, press the FUNC/CL.ADJ. button again to enter the minute mode
with minute digit flashing.
4. Press the SKIP UP/TUNE+ or SKIP-/TUNE- button to adjust the minute.
5. When the correct time is selected, press the FUNC/CL ADJ. button to store the time in the memory.
SETTING THE ALARM TIME
Before starting to set the alarm time, make sure that the unit is in POWER OFF mode.
1. Press the AL1 or AL2 button once and the AL1 or AL2 icon will appear in the display.
2. Press the FUNC/CL. ADJ. button to select the alarm wake up source. You can choose buzzer,
iPod/iPhone, or Radio.
3. Press and hold the AL1 or AL2 button for a few seconds, the alarm hour digit will begin flashing.
4. Press the
/TUNE+ or /TUNE- button to adjust the alarm hour.
5. When the desired alarm hour is selected, press the AL1 or AL2 button again, the alarm minute digit
will begin flashing.
6. Press the
/TUNE+ or /TUNE- button to adjust the alarm minute.
7. When the desired alarm time is selected, press the AL1 or /AL2 button again to confirm.
Note : If you choose iPod/iPhone as the alarm wake up source, please make sure that you have the
iPod/iPhone in place.
TURN OFF THE ALARM
When the alarm activate, press the POWER/AL.OFF button to turn off the alarm.
- 5 -