Operating Instructions

12
a) Insert the strap through the strap slots on the rear housing.
b) Wrap the strap around the mounting surface. Secure the strap and tighten the buckle in order
to secure the camera.
▲ In order to obtain proper weather resistance, please make sure that both door latches are
securely locked in place.
7.2 Turn on the Camera
Just move the “POWER” switch to “ON”, and the camera will be turned on. If there is no operation in
1 minute, the camera will go into the sleeping mode. When the PIR sensor is triggered, it will start to
take photos/video right after the delay time is passed.
7.3 Testing the Camera Coverage Area
One of Night vision camera Scouting Camera’s features is the ability to test the coverage area.
• After mounting the camera, open the front housing and slide the “Power” switch to the “ON”
position and pu
t the camera into the "SETUP" mode (Refer to section 6.1).
• A red indicator light on the front will blink when you have intruded the coverage area.
• Adjust the camera position as needed and repeat testing until the desired coverage area is
achieved.
▲ Make sure to switch the “Power” to “On” and press the "SETUP" button again after setting is
over. Otherwise the camera will not take any pictures or movies.