- Pyle OPERATION MANUAL Microphone System PDWM5300

ManualsBrandsPYLE Audio ManualsHeadphonePDWM5300

OPERATION MANUALOPERATION MANUAL

PDWM5300

UHF PLL Diversity Wireless

Microphone System w/ LCD

UHF PLL Diversity Wireless

Microphone System w/ LCD

PDWM 5300

UHF PLL Diversity Wireless

Microphone System w/ LCD

UHF PLL Diversity Wireless

Microphone System w/ LCD

PDWM 5300

OPERATION MANUALOPERATION MANUAL

PDWM5300

Summary of content (7 pages)

PAGE 1
PDWM 5300 PDWM 5300 UHF PLL Diversity Wireless Microphone System w/ LCD UHF PLL Diversity Wireless Microphone System w/ LCD PDWM5300 OPERATION MANUAL PDWM5300 OPERATION MANUAL
PAGE 2
Thank you for buying the PDWM5300 Wireless System. Please read through these operation instructions so you will know how to operate your model properly. After you read it, put it away in a safe place for future reference. Avoid exposure of the system to rain or moisture. No user-serviceable parts inside the system. Refer all servicing to a qualified technician only. Handle the wireless system carefully, dropping or other shocks may cause failure.
PAGE 3
PARTS DESCRIPTION 1. 2. 3. 4. Mesh: cartridge inside Tube Power LED indicator Power and Mute switch: Switch on and off the microphone. Move the switch to middle position to mute the mic. 5. Battery compartment 6. Battery Cover 7. CH selector 6 + ON OFF + 1. Unscrew the battery cover at the end of the microphone. Install the provided 2 1.5V batteries, taking care to fit it with the correct polarity connected. 2.
PAGE 4
PARTS DESCRIPTION CH00 795.2MHz 00dB AF 1. Power Switch: Turn on power switch, the display of LCD will illuminate. 2. Power LED indicator: Turn on power switch, this indicator will illuminate. 3. SET: Press once to adjust frequency by UP/DOWN buttons. Press again to exit. 4. UP: Channel UP 5. DOWN: Channel DOWN 6. LCD Display 7. Volume control 8. Antenna A and B 9. Balanced output 10. Unbalanced output 11. 12V DC IN OPERATION 1. Connect the antennas A and B. Make sure they are vertical. 2.
PAGE 5
Using the supplied audio cable, connect from the AF OUT jack socket to the LINE IN socket on amplifier. Alternatively, you can connect an XLR cable to the XLR balanced output. Connect the mains power adaptor from "DC 12V" jack to a suitable mains power socket. Installation Location: At least 3 ft. above ground level At Least 3 ft.
PAGE 6
The on air indicator does not light up The wireless microphone is not turned on. The microphone receiver is not turned on. Turn on the microphone receiver and the connected audio equipment The microphone receiver is not connected properly. Turn on the microphone receiver and the connected audio equipment Frequency not set correctly. Make sure mic and receiver are set to the same frequency. The battery in the wireless microphone is weak.
PAGE 7
A. Overall System Carrier Frequency: Frequency Stabilization: Dynamic Range: Total Harmonic Distortion: Frequency Response: Audio Output Level: Mix Type: UHF 795~805MHz less than 30ppm more than 90dB less than 0.5% 40hz~15khz 3dB separate type:0~ 400mV 0~ 200mV B. Receiver Power Supply: DC 12V Consume Power: 4W Signal/Noise Ratio: more than 90dB Image & Spurious Rejection: more than 80dB Border upon Channel Rejection: more than 80dB Receiving Sensitivity: 10dBuv(sinad=30dB) De-emphasis: 50us C.