User`s guide

www.bissell.com 800.237.7691

Maintenance and care

Brush roll reset:

If larger debris becomes lodged in the

foot of the unit and the brush roll shuts

off, turn the unit off and remove the

obstruction. Wait approximately 15 sec-

onds for the motor to cool down before

turning back on. Brush will function

again after allowing time to cool down.

Brush roll belt replacement:

If the brush roll belt should break,

call 1-800-237-7691 or visit WWW.

BISSELL.COM to purchase replacement

belt.

Replacement instructions:

Turn power OFF (O). Remove foot

assembly from unit and turn over to access

the brush roll belt.

2. Remove three Phillips head screws to

remove the belt cover.

3. Locate broken belt.

4. Replace belt.

5. Place brush roll back into foot of unit.

6. Replace the belt cover and secure with

three screws.

7. Attach foot assembly on unit.

Disposal of batteries

If your Lift-Off Floors & More stick vacuum

is to be disposed of, the batteries should

be removed and disposed of properly.

1. IMPORTANT: Unplug Charger.

2. Remove hand vac from unit and remove

dirt cup from handle.

3. Remove (5) Phillips head screws on the

handle and cover.

WARNING:

This product contains Nickel Metal Hydride (NiMH)

rechargeable batteries. According to Federal and State

regulations, removal and proper disposal of NiMH bat-

teries is required. For removal of the batteries in your Lift-

Off Floor & More stick vacuum see instructions below.

Brush roll and brush roll belt maintenance continued

5 screws