User Guide

Middle
(Green LED
is flashing)
High
(Green LED
flashes quickly)
Low
(Green LED
flashes slowly)
17
will be cleared out after all program setting
been cleared out.
Program Pedals as Y axis
1.Press SHARE. Hold for 3 seconds until the
green LED is on.
2.Press LEFT of the D-PAD. The green LED is
off. Pedals are programmed as Y function.
Program L-Wing and R-Wing as Y axis
1.Press SHARE. Hold for 3 seconds until the
green LED is on.
2.Press RIGHT of the D-PAD. The green LED is
off. Pedals are programmed as Y function.
3 levels wheel sensitivity adjustment
1.Press SHARE + OPTIONS at the same time.
Hold for 3 seconds until green LED is on.
Release the button.
2.Press SHARE again. Current sensitivity is
displayed
3.Press SHARE a third time to select
sensitivity level. It cycles as below:
4.Press UP of the D-PAD to confirm and quit.