Setup Guide

22
FCC Regulatory Compliance
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against
harmful interference in a residenal installaon. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instrucons, may cause
harmful interference to radio communicaons. However, there is no
guarantee that interference will not occur in a parcular installaon.
If this equipment does cause harmful interference to radio or television
recepon, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separaon between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modicaons not expressly approved by the party
responsible for compliance could void the users authority to operate the
equipment.
RF Exposure Compliance
This equipment complies with FCC radiaon exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator and
your body. This transmier must not be co-located or operang in
conjuncon with any other antenna or transmier.
blu™ Appendix