User's Manual

8
POWER SUPPLY AND POWER CORD REQUIREMENTS
Power supply class I grounding requirements:
For protection from fault currents, the equipment shall be connected to a grounding terminal.
Plug the system power cord into an AC outlet that provides a ground connection. Substitute
cords may not provide adequate fault protection. Only use the power cord supplied with
this product or an authorized/equivalent replacement
Safety notices:
Denmark:
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse
til stikproppens jord.
Finland:
Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Norway:
Apparatet må tilkoples jordet stikkontakt.
Sweden:
Apparaten skall anslutas till jordat uttag.
ATTENTION
The fuse (T500mAL/250V) provides a safeguard function to the device. When replacing
the fuse, make sure that the value of the replacement matches the value of the original
fuse. Identification of a suitable replacement component or substitute shall be done by
qualified technicians.
The device has been evaluated to meet general RF exposure requirement. To maintain
compliance with FCC's RF exposure guidelines, the distance must be at least 20 cm
between the radiator and your body, and fully supported by the operating and installation
configurations of the transmitter and its antenna(s).