User's Manual

IMEO2 - User manual018

In installations with multiple IMEO2’s installed throughout the building, it can be desirable to assign custom Bluetooth ID’s to

distinguish them from each other. Typical applications are hotels, conference rooms, schools, ... The hotel mode function in

the rmware offers a solution for these applications.

Using the hotel mode, the Bluetooth ID can be adjusted to ‘AUDAC - IMEO2 + xxxx’ where ‘xxxx’ is a 4-digit number,

representing the room number, class number, meeting room number, ...

Additionally, a function is implemented to dene a specic wake-up source, allowing the IMEO2 to always turn-on with the

same input source selected, no matter which input source was selected before power-down.

To enable hotel mode, follow below steps:

Disable auto standby:

Switch IMEO2 to standby mode (upper RED LED illuminated)

Press code ‘6280’ on remote control to enable hotel mode. (see image as below)

(6280 = COAXIAL – BT – PAIR – VOL-)

The Green LED will start to blink (others are continuously illuminated)

Enter the rst number of the 4-digit ID (see image as below)

The Blue LED will start to blink (others are continuously illuminated)

Enter the second number of the 4-digit ID (see image as below)

Repeat for numbers 3 and 4

After the 4 digits of the Bluetooth ID are entered, the upper (standby) LED will start to blink.

Now the wake-up input source can be selected with the last digit:

1: AUX

3: HDMI ARC

0: No specic wake up source

HOTEL MODE

•

The BT name will now be changed to e.g. ‘AUDAC IMEO2 – 1234’ (in

case 1234 was entered) To exit the hotel mode function, press code

‘0826’ on remote control to enable hotel mode.