Technical data

PVI 3000/4000/5000/5300 Installation and Operation Manual

Appendix E Weatherproof Shield for wind-driven snow and rain conditions

The weather proof shield is to be installed on inverters when the chance of rain, snow or severe weather may occur. Examples

of installations needing the shields are:

 Units installed on trackers.

 Units installed outdoors, fully exposed to elements and in climates where severe weather can occur.

Please follow the installation steps below:

Step 1: Remove the eight(8) screws used to fasten the inverter cover. It is not necessary to remove the inverter cover. (Notice:

Don’t throw these eight(8) screws away. The screws will be used to fasten the shields later.)

Fig 6.1 Step 1: Remove the screw of the inverter cover

Step 2: Install the shields on the sides of the inverter and cover the air vents. The larger shield is used for the upper vent and

the small on is for the lower.

Fig 6.2 Step 2: Secure the shields on the sides of the inverter.