Technical data

PVI 3000/4000/5000/5300 Installation and Operation Manual
39
3 seconds ↓
3 seconds ↓
The following message presents that the AC line1 and/or line2 voltage (refer to the neutral) is/are too high (H) or too low
(L)….
X: H or L
3 seconds ↓
The messages for the idle mode are as follows. It shows the operating mode, serial number of the inverter, software versions
of the sequential and current controllers and then the error messages which are listed in the Error Message Table on section 5.
3 seconds ↓
3 seconds ↓
M ode Idle
e r r o r m e s s a g e
S E Q V e r s i o n X . X X
C U R V e r s i o n X . X X
M ode Idle
S / N XXXXXXXXXXXX
M ode Fault
V a c L 1 X V a c L 2 X
T r i p a t XXX . XV
P r e s e n t XXX . XV
M ode Fault
V pvH