Technical data

PVI 3000/4000/5000/5300 Installation and Operation Manual
36
Wpv is the incoming power of the PV array in Watts. Vac, Pac, Iac, and Fac are the voltage, power, current, and frequency
that the inverter feeds to the grid.
3 seconds ↓
3 seconds ↓
3 seconds ↓
The next message shows the cumulated energy in kWh and period of time in hours for the inverter delivering the power to the
grid since the inverter has been power on and operated for today.
3 seconds ↓
The next message shows the cumulated energy in kWh and period of time in hours for the inverter delivering the power to the
grid up-to-date since the inverter has been installed and operated.
3 seconds ↓
There are five possible de-rating displays which will be shown if power de-rating is detected in grid feeding mode. Only one
occasion that causes de-rating could be detected at a time. Therefore, only one of the following messages will be displayed if
power de-rating occurs. When Temp message is presented, the power de-rating is caused by the over temperature. The Ipv
message shows that the power de-rating is caused by restricting the DC input current to the maximum limit. The Iac and Pac
messages illustrate the power de-rating is caused due to restriction of the maximum output AC current and power. The VacH
message shows that the power de-rating is caused by the high AC voltage.
M o d e D e r a t i n g
T e mp
E a c XX XXXX . X k Wh
H XXXXX Hr
E t oday XXX.X kWh
H t o d a y X X . X H r
F a c X X . X H z
I a c X X . X A
V a c XXX . XV
P a c XXXXW
V p v XXXV
W p v XXXXW