Technical data

PVI 3000/4000/5000/5300 Installation and Operation Manual
35
3 seconds ↓
3 seconds ↓
3 seconds ↓
During the monitoring mode, if DC input voltages fall under the PV start voltage setting, the system stays in this mode and
shows the information as follows. The system will still keep measuring the parameters of both DC and AC and display on the
LCD.
3 seconds ↓
3 seconds ↓
3 seconds ↓
After the system enters the grid feeding mode, it will show the following information in order and repeat this until the system
goes to another operating mode.
The first screen shows the current operation mode.
3 seconds ↓
The next messages are the up-to-minute data of the DC input voltages and the AC output voltage. The first two messages are
for the PV array and the other two messages are for the AC output power. Vpv is the incoming voltages from the PV array.
M ode
G rid/MPP
V ac XXX.XV
F ac XX.XHz
Vp v XXXV
M ode Moni tor ing
L o w I n s o l a t i o n
V ac XXX.XV
F ac XX.XHz
V
p
v XXX V
M o d e M o n i t o r i n
N e x t C o n n e c t X X X s
g