Installation guide

29
© 2008 Directed Electronics. All rights reserved.
Remote control learn routine
The system comes with two transmitters that have been taught to the
receiver. The receiver can store up to 4 different transmitter codes in
memory. Use the following learn routine to add transmitters to the sys-
tem.
The Program switch, plugged into the blue port, is used for program-
ming. There is a basic sequence of steps to remember whenever pro-
gramming this unit: Key, Choose, Transmit and Release.
1. Key. Turn the ignition to the ON position.
2. Choose. Within 10 seconds, press and release
the Program switch the number of times correspond-
INGTO THEDESIREDCHANNELLISTEDNEXT /NCEYOU
have selected the channel, press the switch once
more and
HOLD it. The LED will flash to confirm the selected channel.
Do not release the Program switch.
Ch Function
1
Auto Learn Standard Configuration* (default)
The auto learn configuration automatically sets up the remote's button con-
figuration.
2
Delete remotes: This feature erases all remotes from the memory of the security
system. This is useful in cases when a customer’s remote is lost or stolen.
Note: This does not reset the programmed features of the security system or
reset the Virtual Tach setting.