Installation Manual

91009-60, 91009-48
8/8/2016 JRW Page 2 of 3 91009I
6. Use at least 90% Isopropyl Alcohol to prep surface on vehicle where light bar is going to be
installed.
7. Install black plastic brackets with tape onto the back of tailgate light bar. One on each end, then
evenly space out.
8. Remove tape release liner on all brackets. Place light bar in chosen position on the bed of truck.
Do not stick tape to truck until light bar is in correct position. Light bar wire should exit toward
driver side of truck. Refer to Figure 3
Note: (Optional) Brackets may also be mounted with nuts and bolts (not included) by drilling
into the truck. Use a #10 nut and bolt to attach to truck. The brackets will need to be attached
to truck before light bar is installed.
Option 2 Install (Non-Removable)
5. Install 3M tape on back of light bar. Use promotor packet to prep surface on light bar where tape
is going to be applied. Place the four tape strips evenly across the back of light bar. Refer to
Figure 2
6. Use at least 90% Isopropyl Alcohol to prep surface on vehicle where light bar is going to be
installed.
7. Remove tape release liner on all brackets. Place light bar in chosen position on the bed of truck.
Do not stick tape to truck until light bar is in correct position. Light bar wire should exit toward
driver side of truck. Refer to Figure 3
Figure 2
Figure 1
Wire Exit
Figure 3