Installation Manual

Light Bar Kit
LIMITED 2 YEAR WARRANTY
Putco guarantees it’s Stainless Steel and Aluminum products against defects in workmanship and material for as long as you
own your vehicle. All painted products have a 90 day warranty on the painted surface. Any defects resulting from faulty
material or workmanship will be warranted by Putco and repaired or replaced at our discretion. Putco assumes no extra labor
costs. Damages caused by freight carriers, improper installation, misuse, collision, or neglect will not be warranted by Putco.
03/17/2013
Light Bar Installation Instructions
Congratulations on your purchase of a high quality PUTCO product. Should you
need any application or technical assistance feel free to call us at: 1-800-357-9261
Monday-Friday 8:00 a.m. - 5:00 p.m. (Central Standard Time)
Contact your PUTCO dealer for other quality accessories.
Please read all instructions before installation and to check to see that all parts are included.
Tools Needed:
- 7/16” wrench
- 3/4 “ Drill Bit
- Drill
- File
Light Bar Installation
1. Remove light bar from packaging. Check to see if all parts from above table are included.
2. Remove rubber cap, lock nut, and steel washer from light bar. Leave rubber washer on, this will go
between light bar and bracket.
3. Place selected brackets onto light bar, reinstall hardware as shown in (Figure 1). Tighten nut with 7/16”
wrench.
4. Place light bar and mark bracket holes in desired location. Remove light bar and drill holes to the size
required for your chosen mounting hardware.
5. Mount light bar with chosen hardware in your desired location.
KIT CONTENTS:
Description Qty.
Light Bar
1
Wiring Harness
1
Illuminated Switch
1
Long Bracket
2
Short Bracket
2
¼”-20 Lock Nut
2
Black ¼” Steel Washer
2
Black ¼” Rubber Washer
2
Rubber Cap
2
Figure 1