Specifications

Configure on iPhone / iPad

Step1: Connect your iPhone to the wireless router as the camera connected.

Step2: Open “EagleEyes” on your iPhone or iPad.

In the address book, click “+” to add new device. Then, select “Local Network Search” to search your

network camera. You’ll see two IP addresses as shown below.

Ignore 192.168.2.10, and select the other IP address, such as 192.168.2.105 in our example, to enter the

setting page.

Note: The other IP address, such 192.168.2.105 in our example, is the address assigned by your

wireless router, and may vary depending on the router you’re using.

Note: If you can’t find the camera, make sure your LAN status indicator ( ) is always on, and search

again after 3 minutes.

Step3: Select the IP address you want to

configure to show the IP address setting

page.

The default port number is 88. You may

change it to any value (such as 8080) if

the port number of 88 is blocked.

Then, note down the IP address and port

number you see here. You might need

them for port forwarding later.