Specifications

29
Step5: Go to “Config.”  “DDNS”, and enable the DDNS service.
 If your router supports UPnP, please proceed Step6.
 If your router doesn’t support UPnP, click “Save”, and access your router for port forwarding as instructed in “APPENDIX 5
CONFIGURE PORT FORWARDING” at page 38.
Step6: Go to “UPnP”, and enable the UPnP service.
Then, enable “Port Mapping”, and click “Save” to start port mapping.
When the configurations are saved successfully, you’ll see a message indicating the IP address and port
number assigned to your device.
Note down the IP address and port number, and log out the camera.
You can use the host name you noted down in Step5 to access your camera, such as
MAC000e531d6ff1.ddns.eagleeyes.tw, or the IP address shown in Step6 to access your camera.
And the default port number is 88.
Step7: Check the Internet status indicator ( ):
 If it’s always on (no blinking), the network setup is successful.
 If it blinks after 5 seconds*, please continue with configuring port forwarding as instructed in “APPENDIX 5 CONFIGURE
PORT FORWARDING” at page 38.
*The blinking frequency is 5 seconds on  0.5 second off  0.5 second on  0.5 second off  5 seconds on.
Check your connection
Step1: Check if the LAN ( ) and Internet ( ) status indicators on the camera are always on.
Step2: Connect your laptop / computer to Internet by using other network, and open Internet Explorer. Or, switch
the network mode of your smart phone to 3G, and open the built-in web browser.
Step3: Enter the IP address or host name you just noted down and the port number in the URL address box of
the web browser, and see if you can access the login page of the camera successfully.
The format is “http://ipaddress:portnum” or “http://hostname:portnum”.
 If yes, your network setup is successful.
 If no, go to Step4.
Step4: The port you’re using for this camera might be blocked by your Internet service provider or phone carrier.
Please start from Step2 of “Configure on Laptop / Computer”, and change the port number to another
value.
Step5: Complete the setup, and examine your connection again as instructed in “Check your connection”.
.