Specifications

19
Step5: In the new device page, give a meaningful
name for this connection in “Title”, and
click “Save”.
Step6: Go to “Check your connection” below to
examine your connection.
Check your connection
Step1: Check if the LAN ( ) and Internet ( ) status indicators on the camera are always on.
 If they’re both always on (no blinking), go to Step2.
 If the Internet status indicator ( ) blinks after 5 seconds*, please continue with configuring port forwarding as instructed in
“APPENDIX 5 CONFIGURE PORT FORWARDING” at page 38.
*The blinking frequency is 5 seconds on  0.5 second off  0.5 second on  0.5 second off  5 seconds on.
Step2: Switch the network mode to 3G mode on your android device.
Step3: Start EagleEyes, and select the connection you just added to see if you can access the camera
successfully.
 If yes, your network setup is successful.
 If no, go to Step4.
Step4: The port you’re using for this camera might be blocked by your phone carrier. Please start from Step1 of
“Connect a camera to the Internet”, and change the port number to another value.
Step5: Complete the setup, and examine your connection again as instructed in “Check your connection”.
1.5 Change Default Account
To ensure your account safety, please access the camera after network configuration to change the default user
name and password with new one you prefer.
1.5.1 From Web Browser
Log into the camera, and select “Config.”  “General”  “Account”.
Select the default account “admin”, and click “Edit” to change the default password.