Specifications

16
Step3: Select the IP address you want to
configure to show the IP address setting
page.
Then, switch to the tab “Static”.
The default port number is 88. You may
change it to any value (such as 8080) if
the port number of 88 is blocked.
Then, note down the IP address and port
number you see here. You might need
them for port forwarding later.
Note: It’s not recommended to use the port
number of 80 since some phone carriers
might block this port for network access.
Step4: Select “Apply” to confirm all your
changes. Then, wait till you see “Done”
or “Fail” in “Status”.
Regardless which message you see,
proceed as instructed below:
 For Done, you’ll return to the new device
page.
 For Fail, select “
” on the top right side.
You’ll later be prompted to select “DDNS” or
“Local IP”. Select “DDNS” and return to the
new device page.
Step5: In the new device page, give a meaningful
name for this connection in “Title”, and
click “Save”.
Step6: Go to “Check your connection” below to
examine your connection.