Specifications

15
1.4.2 Configure on iPhone / iPad
Before configuring this camera on iPhone / iPad, make sure:
 You have installed our mobile program, EagleEyes-Lite or EagleEyes-Plus, on your iPhone or iPad. For
details, please refer to “APPENDIX 3 MOBILE SURVEILLANCE VIA EAGLEEYES” at page 35.
 (Recommended) Your wireless router supports UPnP, and this function is enabled.
Note: If your wireless router doesn’t support UPnP, you need to additionally access your router for port
forwarding. For details, please refer to “APPENDIX 5 CONFIGURE PORT FORWARDING” at page
38.
 Make sure your connection is as illustrated
 Connect your iPhone / iPad to the wireless router with the camera connected, and go to “Settings”  “Wi-Fi”.
Select “>” near the selected wireless network to enter the details.
The IP address shown in “Router” is the IP address used by your wireless router. In the following example,
the IP address of your router is 192.168.2.1.
Note: This address will be needed when you want to access your router for port forwarding later.
Connect a camera to the Internet
Step1: Connect your iPhone to the same wireless network (SSID) as the camera connected.
Step2: Open “EagleEyes” on your iPhone or iPad.
In the address book, click “+” to add a new device. Then, select “Local Network Search” to search your
network camera. You’ll see an IP address assigned by your router.
Note: If you can’t find the camera, make sure your LAN status indicator ( ) is always on, and search
again after 3 minutes.