Product specifications

2
1.4 Rear Panel
RJ45 Port: Connect your network cable.
Power: Connect the supplied regulated power supply.
External I/O Port A 4-pin I/O terminal is supplied with the camera for external alarm device connection. For
details, please refer to “1.5 External I/O Port” at page 2.
Reset Button: With the power connected, press to reset all parameters, including the IP address to factory
default settings.
The camera will reboot after default reset. Please do not disconnect your camera during the
reset process.
Button for quick wireless
network connection:
Used to quickly connect to your wireless network with simply one press if your wireless router
also supports this function. For details, please check the user manual of your wireless router,
and the instructions in the printed “Quick Setup” supplied with the camera.
1.5 External I/O Port
This camera supports external I/O device connection, and a 4-pin I/O terminal is supplied with this camera for
easy connection.
Below shows which input on the I/O terminal you should use for wiring when you want to connect an external
device to this camera.
4-pin I/O Terminal Alarm Out Connection
1.6 Status Indicator
ICON
LAN connection status Internet connection status
System Status
During powering on Always on Always on
Blinking (on 250 ms, off 250 ms) Always off
Reset default

Blinking (on 250 ms, off 250 ms) Blinking (on 250 ms, off 250 ms)
Upgrade
 
Connection Status
LAN connected Always on --
Blinking (on 100 ms, off 500 ms) --
LAN disconnected

Internet connected -- Always on
Blinking (on 100 ms, off 500 ms)
Internet disconnected --

Network Setup Incomplete
--
Blinking
(on 5 sec, off 0.5 sec, on 0.5 sec, off 0.5 sec, on 5 sec)
Port forwarding required
-- 
* LED blinking frequency -  LED on /  LED off