Owner`s manual

SF 345
25
switch position. Turning off the power steering at low speeds will reduce the sensitivity of the steering. To
conserve battery power, due to limited engine charging output during extended periods of slow speed
operation, the power steering should be turned off. Refer to the Teleflex® Power Assist manual for further
information.
2.9 Compass
The compass is on top of the helm. To adjust the compass, read the instructions on “Compass Compensation”
given to you in the literature packet. The compass cannot be adjusted accurately at the factory as it must be
compensated for the influence of the electrical equipment and electronics unique to your boat. Therefore,
the compass should be adjusted by a professional after the electronics and additional electrical
accessories are installed and before operating the boat.
2.10 Control Systems Maintenance
CONTROL MAINTENANCE
Periodic inspection of the control systems and all connections should be made. Signs of rust, corrosion, wear,
or other deterioration should immediately be serviced. Generally, periodic lubrication of all moving parts and
connections with a light waterproof grease is in order.
Control system adjustments may become necessary. If adjustments become necessary, see your Pursuit dealer.
INSPECT AND MAINTAIN THE STEERING SYSTEM REGULARLY. DO NOT ATTEMPT
CONTROL ADJUSTMENTS UNLESS YOU ARE FAMILIAR WITH SERVICING CONTROL
SYSTEM PROCEDURES. CONTROL MISADJUSTMENT CAN CAUSE LOSS OF CONTROL
AND SEVERE ENGINE OR LOWER UNIT DAMAGE.
STEERING SYSTEM MAINTENANCE
A periodic inspection of all steering hoses, linkage and helm assemblies should be made. Signs of corrosion,
cracking, loosening of fastenings, excessive wear or deterioration should be immediately corrected. The fluid
level for the hydraulic steering should be checked frequently and maintained at the proper level. Generally,
periodic lubrication of all moving parts and connections with a light waterproof grease is in order. Failure
to do so could lead to steering system failure that would result in loss of control.
When new, or after repairs, hydraulic steering systems may need to have all air purged from the system.
Review the information provided by the steering manufacturer for proper specifications and details on system
service and maintenance.
FOLLOW INSTRUCTIONS IN THE OWNER'S INFORMATION PACKET FOR HYDRAULIC
STEERING SYSTEM OPERATING, BLEEDING PROCEDURES AND MAINTENANCE PRO-
CEDURES.
TRIM TAB MAINTENANCE
Marine growth can interfere with the proper operation of the trim tab planes and actuators. To reduce problems