Installation Sheet

Plumbing

All Purewater

Pipeless Whirlpool Bath units are factory tested for proper operation and watertight connections prior to

shipping. Prior to installation, the bath must be filled with water and operated to check for leaks that may have resulted

from shipping damage or mishandling. If leaks are detected, notify Purewater Baths’s customer service department. Do

not install the unit.

DRAIN INFORMATION

A drain/overflow assembly must be installed on the bath, water tested, and connected to the sanitary system of the

house. After opening the box that contains the drain / overflow assembly (optional accessory), inspect for damage and

verify it has the proper finish. Follow the installation instructions provided with the drain/overflow assembly kit.

NOTE: Watertight installation of the drain is the installer’s responsibility and is not covered under the product’s warranty.

WATER SUPPLY

Consult local authorities for plumbing code requirements in your area.

IMPORTANT: Proper installation of faucetry and waste/overflow, as well as compliance with local codes are the responsibility

of the installer. Purewater Baths® does not warrant connections of water supply fittings and piping, faucetry, or waste/

overflow systems. Nor is it responsible for damage to the bath that occurs during installation.

CAUTION: A nonflammable protective barrier must be placed between soldering work and the bath unit to prevent damage

to the bath.

SHOWER INFORMATION

Purewater Baths

is not responsible for damage to the bath unit or for water damage, which might occur due to improper

shower installation or use.

CLEANING THE BATH UNIT AFTER FINAL INSTALLATION

To avoid dulling and scratching the surface of the bath, never use abrasive cleaners. A mild liquid detergent and warm

water will clean soiled surfaces. Remove spilled plaster with a wood or plastic edge. Metal tools will scratch the surface.

Spots left by plaster or grout can be removed, if lightly rubbed with detergent on a damp cloth or sponge.

Paint, tar, or other difficult stains can be removed with paint thinner, turpentine, or isopropyl alcohol (rubbing alcohol).

To avoid discoloration, cleaners containing petroleum distillates must not remain on surfaces. NEVER use lacquer thinner

or chlorinated solvents.

Minorscratchescanbeeasilyremoved.Immerse600-gritwet/drysandpaperinwaterandlightlysandthearea.Repeat

sanding with 1000-grit wet/dry sandpaper and water. To restore the surface gloss, use Gel-Gloss® (found at most

hardware stores). If that is not available use automotive rubbing compound followed by an application of automotive

paste wax. Major scratches and gouges, which penetrate the acrylic surface, will require refinishing. Contact Purewater

Baths’s customer service department for specific instructions.

TROUBLESHOOTING

If system will not operate: Check the remote GFCI to make sure it is in the ON position. Reset GFCI if necessary.

NOTICE: Abnormal operation of the whirlpool bath functions may be the result of a power outage or poor quality power

service in your area. The circuit breaker, which supplies electrical power to the whirlpool bath, should be reset prior to

placing a service call.