User Manual

3
Installations
This chapter describes on how to install and power
on your USB Port Card Reader.
Hardware Installation
step 1:step 1:
step 1:step 1:
step 1:Switch on your computer.
step 2:step 2:
step 2:step 2:
step 2:After the computer enter to the win98. Plug
the device terminal of the USB cable into the
connector, shown as figure 1, The other side
of the transmission line has to connect to the
USB port of the computer, shown as figure 2.
step 3:step 3:
step 3:step 3:
step 3:At the mean time, the windows will notify that
there is a new hardware found, please refer to
the page (Installation Procedures for Windows
98 / Windows 2000).
Chapter 2
figure 2
figure 1