FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection.
learn] Pan-European Approval The equipment has been approved in accordance with Council Decision 98/482/EC for pan European single terminal connection ta the public switched elephant network (PST. However, due to differences between the individual PST's provided in different countries, the approval does nat, of itself, give an unconditional assurance of successful operation on every PST network termination point. in the event of problems, you should contact your equipment supplier in the first instance.
= 3S MEGALOMANIA RE ATS11=95 (MOTIF priced between 70255ms) A total of 3 calls attempts are allowed to a telephone number, with a minimum pried between calls of 2 secants; if the call doesn't connect after 3 attempts, 30 minutes must expire before automatic redialing may be irritated Failure to set the modem {and any associated communications software) ta the above setting may result in the madam being non-compliant with ACA Technical Standards.
8 1 prey iii 35 TROUBLEMAKER AS 3. For Safety reasons, only connect equipment with a Telecommunications Compliance Label. This includes customer equipment previously labeled, permitted or certified. 4. To ensure continuing compliance with ACA Technical Standards, a Gigawatt SF-4 fer rite or equivalent must be fitted to the cabin of any external microphone and / or speaker connected to the external modern .
& = 35ITEGISMANUALL 6S Tre application using the made is compatible with the application at the other end of the call. £.g. accessing the Internet requires suitable software in addition to a modem. This equipment shall nat be used in any manner which could constitute a nuisance to other Telecommute customers. Some parameters required for compliance with Telecommute PTC Specifications ars dependent cn the equipment {PC} associated with this modem.
= ISITEGISMANUALL263 BOAT {CIT operation) AT&G2 {1800 Hz guard tone) ATTY {Decade dialing make break ratio =33% /67%] ATS0=0 (not auto answer) ATS11=65 (MDT dialing on/off duration = 65 ms} ATAXIA {dial tone detect, but not {U S.A) can progress detract} When used in the Auto Answer mode, the SC register must be set with a value between 2 and 10. This ensures: A person calling your modem will hear 2 hart burst of ringing before the © made answers.
ml 15ITEGISMANUAL2965 Tl mi disconnected from the Telecommute line dung electrical storms. * When relocating the equipment, sashays disconnect the Telecast fine connection before the power connection, and reconnect the power first. No o Please ante that fault callous caused by MSE ny of the above causes may incur a charge from Telecommute.
7 LEGISLATE MANY ALL 6S Canadian DOC Notice The Canadian Department of Communication fable identifies certified equipment. This certification meats that the equipment meets certain telecommunications network protective, operational, and safety requirements. The Department does not guarantee the equipment will work ta the user satisfaction. Before installing the equipment, users should ensure that iris permissible to be connected 0 the facilities of the local telecommunication company.
Il GITES MANUAL 285 earphone lines, and internal metallic water pipe systems, if present, are connected together. This precaution may be particular important in rural areas. connections themselves, but should car tact the appropriate electric inspection authority, ar electrician, as appropriate.
«Only the manufacturer can make repairs 10 the modem. Other repair methods will vied your warranty « If you have an external modem, use 3 properly constructed shielded cable to connect it to your computer.
his information must be given ta your telephone company. The REN is used to determine the guaranty of devices you may connect to yur telephone fine and still have ail of those devices ring when your number is called. (n.
Table of Contents Chapter 1 Introduction Features 1 System Requirements z Package Checklist 2 Chapter 2 Installations Hardware Installation 3 n instillation Procedures for “gr Win 98... a % installation Procedures for Wir NT4.0 3 Communication Software , INSTITUTION ores B Chapter 3 Commands Typing Commands 9 AT Commands 10 S-Register Definitions...
= 35:TEGH MAN TALL p85 Introduction The Voice/Fax/Cata PC Modern connects your computer to Internet, all kinds of BBS, and other fax moderns. This manual describes the features, installation procedures and AT commands. Ta Paar 5 . 0 Thane Phone : Phone jack Taine ~ Line : Telephone line jack To MIC MIC: Microphone jack To Speaker + SPK : Speaker jack(for ’ Serena only) jack Features This made supports the following communication standards. IT-T is known as COT. Data = = Rockwell K56fiex + V.328is, V.32, V.
SITE MANUAL ak Shane 1 2] = {4800bps FAX) Voice = Veice/Audia mode = Full-Duplex speakerphone = TUT V.67 AudioSpan(Simultaneous System Requirements * Windows™ 35, Windows™ 28, Windows™ NT 4.
Chapter 2 Installations This chapter describes how to install 2nd power on you fax modem. Hardware Installation 1. Make sure that your computer is switched off. Unplug the power cord farm the wail socket. Alas turn off all either peripherals you may have attached to your computer. 2. Select a fare PCI slot. Remove the cover from the slot, Keep the screw. You will be @ using tin the next step. © 3. Carefully slide the internal modem inch the chase slot. Press firmly on the tap of the modem to seat it.
Cheerer end of the phone cable should be connected directly to the phone outlet. if yau desire, you could connect your fore ta the modem's Thane jack. w Turn an your computer. o Installation Procedures for Windows™ $8 1. Once you have completed the hardware ‘installation, power an your computer. When running Win 98, your system wil detract a new device and the feeling message will appear, Click " Next ™.
TS Cem? 2, Select the Search for the best driver for your device {Recommended) option, then click Next. Place the CO containing driver for Win 9X into your CD ROM drive. Specify the location of the modern driver, 2.g., EAROCKWELLVPCIMODEM \COUNTRYWIDE (select the appropriate courtly. Click Next.
Charioteer 2 if rhe country you require is not listed, Note please select" OTHER * {i.e £3 ROCKABILLY DEMODE A OTHER | WINGS). Please note that the driver for Note Windows™ 95 and Windaws™ 98 is contained under the \WINS directer. Piste The dre for Windows NT 4.0 could 4 be forearmed under the \ WINNING 40 directory SITE MANUAL 2S 9 19017, PM 2225
INTELLECTUALISM p65 Chapter 2 Installation Procedures for Windows NT4.0 1. Place the CD into your CD-ROM driver, Soe iffy the location of the modem driver, e.g, ROCKWELL \ PO MODEM \ USA\WINNTAC then run Setup exe 2. You should see a welcome screen . Click on the * Next “ button . You should see “ Contestant HCF 56K Speakerphone PCL Madam “ in the display Windows . click an the “ Next * button to install the driver . 3.
r 7] crapper 3 Commands Most people use the communication software programs to tell modems what to do. Thereafter, you may not use the commands in this chapter. However, if you prefer to communicate with your made directly, you can type the commands described below, This chapter describes how to work in the terminal made. The CO bundled in your fax modem Note package contains details on AT commands (file path: &XAROCKWELLPCIMODEM “ \COMMANDANT PDF).
INTELLECTUALISM: 355 Chapter 3 [15] All defaults are based on the &F Hardware Flow Control template lead in RAMON when the modem is shipped. AT Commands AN A Re-executes the last issued command. Used mainly to redial. Go off-hock and attempt to answer 2 call. ATS? Read Selected S-Register. This commander reads and displays the selected S-Register. An S-Register can be selected by using the ATS# command.
[EE Apart “OK” Report “OK” or “ERROR” Report firmware revision Report OEM defined identifier string Report modem data pump model and internal cede revision | EXQUISITE EMANUEL 26S FEUD On cq ci Sr=n Speaker Contort Speaker is always off Speaker ON until CONNECT Speaker is always on Speaker off during dialing and receiving carrier and turn speaker on during answering.
Chaster 3 12 &Cn Control Carrier Detect (CD) Sinai 8C0 CD override &C1 Normal CC operations &Dn Adoption 800 Signora an on-to-off transition of OTR &C1 Switch to on-line command made without disconnection. &D2 Normal DTR operations. &03 Modem re-initialized. &Y determines which profile is leaded &Fn Load Factory Configuration {Profile} &F0 Restore factory configuration 0 &F1 Restore factory configuration 1 <&Wn Store Current Configuration &WO Store the current configuration as profile 0.
14} K56 Ks8 $6000, 34000, $280¢, 48006, 46000, 44000, 42000, 4000C, 38000, 36000,34000, 32000 3103 {Bell 103 | 300 : 8212 [Belle 1208 Chaucer 3 automotive Option Selected ¢ Automate disabled © 1 Auto mods enabled © Example © Where REFLEXIVE select FLEXING 1 ! auto mode enable 300 terminate data speed 300 ops 38000 maturate data speed 56C00 bps If you want ta select V.
| 12} ISITSOISMANUALL 965 Chanter 3 S-Register Definitions Number of Rings to Auto-Answer The number of rings the modem waits for before it auto answers. Range.
SITE EMANATES 265 S10 51 Chaser 3 Te Range 1-255 Default 60.6 second} Lost Carrier To Hang Up Delay The time the modem waits before hanging up far carrier loss. age. 1-253 Default: 14 (1.4 seconds) MDT Tone Duration The me for MDT tone dialing and the time between the tone spacing. Range: 50-235 Default: 95 {0.
