User Manual

§ When used in the Auto Answer mode, the
S0 register must be set with a value
between 2 and 10. This ensures:
- A person calling your modem will hear
a short burst of ringing before the
modem answers. This confirms that the
call has been successfully switched
through the network.
- Caller identification information (which
occurs between the first and second
ring cadances) is not destroyed.
§ This equipment does not fully meet
Telecom’s impedance requirements.
Performance limitations may occur when
used in conjunction with some parts of the
network. Telecom will accept no
responsibility should difficulties arise in
such circumstances.
§ It is recommended that this equipment be
disconnected from the Telecom line during
electrical storms.
§ When relocating the equipment, always
disconnect the Telecom line connection
before the power connection, and
reconnect the power first.
Please note that fault callouts caused by
any of the above causes may incur a
char ge from Telecom.
v