User Manual

&C&C
&C&C
&C
nn
nn
n
Control Carrier Detect (CD) SignalControl Carrier Detect (CD) Signal
Control Carrier Detect (CD) SignalControl Carrier Detect (CD) Signal
Control Carrier Detect (CD) Signal
&C0 CD override
&C1&C1
&C1&C1
& C 1 Normal CD operations
&D&D
&D&D
&D
nn
nn
n
DTR OptionDTR Option
DTR OptionDTR Option
DTR Option
& D 0 Ignore an on-to-off transition of DTR.
&D1 Switch to on-line command mode
without disconnection.
&D2&D2
&D2&D2
& D 2 Normal DTR operations.
& D 3 Modem re-initialized. &Y determines
which profile is loaded.
&F&F
&F&F
&F
nn
nn
n
Load Factory ConfigurationLoad Factory Configuration
Load Factory ConfigurationLoad Factory Configuration
Load Factory Configuration
(Profile)(Profile)
(Profile)(Profile)
(Profile)
&F0 Restore factory configuration 0
&F1 Restore factory configuration 1
&W&W
&W&W
&W
nn
nn
n
Store Current ConfigurationStore Current Configuration
Store Current ConfigurationStore Current Configuration
Store Current Configuration
& W 0 Store the current configuration as
profile 0.
& W 1 Store the current configuration as
profile 1.
+MS+MS
+MS+MS
+MS
Select ModulationSelect Modulation
Select ModulationSelect Modulation
Select Modulation
This command selects the modulation,
optionally enables or disables
automode, and optionally specifies the
lowest and highest connection rates
using one to four subparameters.
The format is:
AA
AA
A
T+MS=<carrier>,<automode>,T+MS=<carrier>,<automode>,
T+MS=<carrier>,<automode>,T+MS=<carrier>,<automode>,
T+MS=<carrier>,<automode>,
<min_tx_rate>,<min_tx_rate>,
<min_tx_rate>,<min_tx_rate>,
<min_tx_rate>,
<max_tx_rate>,<max_tx_rate>,
<max_tx_rate>,<max_tx_rate>,
<max_tx_rate>,
<min_rx_rate>,<max_rx_rate><min_rx_rate>,<max_rx_rate>
<min_rx_rate>,<max_rx_rate><min_rx_rate>,<max_rx_rate>
<min_rx_rate>,<max_rx_rate>
11
Chapter 3