User Guide

13 Copyright © Puretec Pty Ltd 2023 SOL-E3 User Guide
Programming
6.1 Plug into an uninterrupted electrical outlet.
Note: the system transformers are not weather resistant and should be
adequately protected. All electrical connections must be connected accordingly to
local codes.
6.2 Proceed to ‘Programming’ section.
9
Connecting the Drain Line
Connecting the Overflow
7
8
Connect tubing onto the 5/8” overflow
fitting (tubing not supplied) and run the
line to the drain. Do not connect the
overflow into the drain line, as it must
be a direct and separate line to the
drain. Allow an air gap as per the drain
line. Make sure the drain is not higher
than the overflow.
Connect extra tube (tubing not supplied)
onto the 5/8” drain line (pre installed on
the valve) from the valve to the drain.
Ensure the drain line is not kinked. The
line must not travel more than 2.4 m and
no more than 6 m long from the valve,
otherwise increase the diameter of the
drain line.
Connect drain and overflow to sewer or
other approved salty water disposal point
as approved by your local authority.
Ensure drain line has an adequate air gap
of 2 times the pipe diameter or 25 mm,
whichever is larger.
DRAIN
DRAIN
Installation Procedure