User Guide

Position the Soener on a level surface. The unit must be installed on a surface or

pad that is stable, level and able to support the entire base and wet weight of the

unit.

Installing the Bypass (optional - purchased separately)

Environmental conditions

Operating temperature: 0 - 48°C

Water conditions

Temperature: 0 - 50°C

Pressure: 138 - 862* kPa

* Where line pressure exceeds 500 kPa, an approved pressure

limiting device must be installed to comply with Australian &

New Zealand Plumbing Standards. (Ref. AS/NZS 3500.1:2021,

Clause 3.3.4).

Uninstall the plastic ﬁttings

by turning the knob counter

clockwise.

Connect the bypass assembly followed

by the plastic ﬁttings. Hand tighten the

knobs, do not overtighten.

Refer to page 18 for bypass operation.

Installation Procedure