Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 90
T00 Auto T09 1080p (50Hz) T18 SXGA (1280x1024@75Hz)
T01 480p (60Hz) T10 1080p (59Hz) T19 SXGA (1280x1024@85Hz)
T02 576p (50Hz) T11 1080p (60Hz) T20 UXGA (1600x1200@60Hz)
T03 720p (50Hz) T12 SVGA (800x600@60Hz) T21 1360x768@60Hz
T04 720p (59Hz) T13 SVGA (800x600@75Hz) T22 1366x768@60Hz
T05 720p (60Hz) T14 XGA (1024x768@60Hz) T23 1440x900@60Hz
T06 1080i (50Hz) T15 XGA (1024x768@75Hz) T24 1920x1200@60Hz
T07 1080i (59Hz) T16 XGA (1024x768@85Hz)
T08 1080i (60Hz) T17 SXGA (1280x1024@60Hz)
Example:
Command Codes Action
*255OEO01T00!  Set Output 1 Extender Scaler timing to Auto
*255OEO02T11! Set Output 2 Extender Scaler timing to 1080p
OP: Output Extender Command Transmission (Pass Through Mode)
The "OP" is an initiation command for send command to the device that is connected to
the Output Extender's rs-232/422 port. The characters and numbers that follow the "OP"
command tell the system, send a command to the device through Output Extender. The
last character “!” is found at the end of a command code which tells the system to
execute the command.
In order to send control command to the AV devices that are connected to the PM
Extender, it needs to open the communication port and then send a command;
Port open command: *255OPO01@001! 
Command to the AV devices: O01"21 89 01 50 57 30 0A 0D"0D
Port close command: *255OPC!
<Carriage return in HEX format>
RS-232 Baud rate(bps) :
@001:4800 @002:960 0 @003:14400
@004:19200 @005:384 00 @006:57600
@007:76800 @008:1 15200
For example, the command code
*255OPI01@001! 
"*(type code)! "  <Please note that there should be two carriage return for this