Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 87
For example, the command code
*255OMO01A,O02M,O03S! 
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255
(OM) Output Audio selection on HDMI/SDI ports on (O01) Output 01 to (A) auto mode,
(O02) Output 02 to (M) Embedded Audio, (O03) Output 03 to (S) 3.5mm Audio (!) take
the command. For a complete list of command characters and their functions, see
examples below.
Output HDMI/SDI Ports Audio Select
A: Auto, M: Embedded Audio, S: 3.5mm Stereo Audio
(M) Embedded Audio refers to embedded Audio from Input source side
(S) 3.5mm stereo Audio refers to inserted Audio from Output Board's 3.5mm stereo
jack
Note) For PM-128X and PM-256X, input and output # uses three digit format, instead
of two digits. For example;
Input 01 (I001), Input 05 (I005), Output 01 (O001) and Output 100 (O100)
Example:
Command Codes Action
*255OMALLM!  Set all HDMI/SDI Output Audio selection to embedded
*255OMO01A,O02M,O03S!

Set HDMI/SDI Output Audio on Output 1 (Auto),
Output 2 (embedded), and Output 3 (3.5mm stereo
Audio)
*255OMO01-09M!  Set HDMI/SDI Output Audio on Output 1~9 to
embedded
OS: Output Audio Select on CATx/Fiber port
The "OS" is an initiation command for Input Audio selection on CATx/Fiber port. The
characters and numbers that follow the "OS" command tell the system, which Output #'s
CATx/Fiber Audio will be set to which Audio source. The last character “!” is found at
the end of a command code which tells the system to execute the command.
For example, the command code
*255OSO01A,O02M,O03S! 