Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 82
IV: Input Video Source Select
The "IV" is an initiation command for Input Video selection. The characters and
numbers that follow the "IV" command tell the system, which Input # will be set to which
Video source. The last character “!” is found at the end of a command code which tells
the system to execute the command.
Note) For PM-128X and PM-256X, input and output # uses three digit format, instead
of two digits. For example;
Input 01 (I001), Input 05 (I005), Output 01 (O001) and Output 100 (O100)
For example, the command code
*255IVI01A,I02M,I03S! 
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255 (IV)
Input Video selection on (I01) Input 01 to (A) auto mode, (I02) Input 02 to (M) HDMI/SDI,
(I03) Input 03 to (S) DVI/CATx/Fiber (!) take the command. For a complete list of
command characters and their functions, see examples below.
Input Video Source Select
A: Auto, M: HDMI/SDI, S: DVI/CATx/Fiber
* For HDMI Input Board, only M (HDMI) can be selected
* For SDI Input Board, only M (SDI) can be selected
* For DVI Input Board, M (HDMI) or S (DVI) can be selected
* For CATx Input Board, M (HDMI) or S (CATx) can be selected
* For Fiber Input Board, M (HDMI) or S (Fiber) can be selected
Example:
Command Codes Action
*255IVALLM!  Set all Input source to HDMI/SDI
*255IVI01A,I02M,I03S!  Set Input 1(Auto), Input 2(HDMI/SDI), Input3
(DVI/CATx/Fiber)
*255IVI01-09M!  Set Input1 ~ 9 to HDMI/SDI
IA: Input Audio Source Select
The "IA" is an initiation command for Input Audio selection. The characters and
numbers that follow the "IA" command tell the system, which Input # will be set to which