Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 77
because the Input number was not
included
*255CI01O01  Command Code Error
The command was not executed
because “!” (End) was not included
*300CI01O01!  Router ID Error
The command was not executed
because the actual Router ID and
entered Router ID did not match
Connecting Switches
A switch is an active connection between an Input (source) signal and one or more Output
(display) devices. The signals connected in a switch command are either individual signals or
groups of signals coming through the connectors on the rear of the unit.
* Audio commands are for the independent green blocks Audio Matrix Router
The “C” key initiates a Connect command for routing a switch. The characters and numbers
that follow the “C” command tell the system, which Inputs and Outputs to connect. The last
character “!” is found at the end of a command code which tells the system to execute the
command.
For example, the command code
*255CI01O01! 
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255 (C)
Create connection on (I01) Input 01 to (O01) Output 01 (!) take the command. For a
complete list of command characters and their functions, see examples below.
To connect a switch:
Enter the Connect command below. Replace the “#”s with the Input and Output
number(s).
*255CI#O#! 
Note) For PM-128X and PM-256X, input and output # uses three digit format, instead
of two digits. For example;
Input 01 (I001), Input 05 (I005), Output 01 (O001) and Output 100 (O100)