Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 64
both 1S and 1J are active, it will Output 1S. Factory default is set to
1S.
1S: Set Output Audio into Embedded Audio
In here, embedded Audio represents Audio from selected Input's
Audio
1J: Set Output Audio into 3.5mm stereo Audio
In here, 3.5mm stereo Audio represents inserted Audio from Output
Boards' 3.5mm stereo Audio jack.
CATx/Fiber Audio: There are three options to configure Output Board's CATx/Fiber
Output port.
2A: Set Output Audio into Auto mode
PM series Matrix Router will detect signals between 2S (Embedded
Audio from Router's Input) and 2J (inserted Audio from Output
Boards' 3.5mm stereo Audio jack) and Output whichever is active. If
both 2S and 2J are active, it will Output 2S. Factory default is set to
1S.
2S: Set Output Audio into Embedded Audio
In here, embedded Audio represents Audio from selected Input's
Audio
2J: Set Output Audio into 3.5mm stereo Audio
In here, 3.5mm stereo Audio represents inserted Audio from Output
Boards' 3.5mm stereo Audio jack.