Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 63
PM series Matrix Router will detect signals between AS (Embedded Audio
from HDMI source or PM Extender Transmitters) or AJ (inserted Audio from
Input Board via 3.5mm stereo Audio jack) and Output whichever is active. If
both AS and AJ are active, it will Output AJ. Factory default is set to AS.
 AS: Set Input Audio into Embedded Audio
In here, embedded represents either embedded Audio from Input Boards'
HDMI port or Audio from PM Extender Transmitters
 AJ: Set Input Audio into 3.5mm stereo Audio
In here, 3.5mm stereo Audio represents inserted Audio from Input Board via
3.5mm stereo Audio jack
2) Output Configuration
Output: It displays current Output Board's Audio configuration. Only Audio option can be
configured on Output Boards. First select Output # that wishes to make a change
on Output section and then use HDMI/SDI Audio and CATx/Fiber Audio section for
configuration. Multiple Input #s can be selected at once.
HDMI/SDI Audio: There are three options to configure Output Board's HDMI and SDI Output
port.
1A: Set Output Audio into Auto mode
PM series Matrix Router will detect signals between 1S (Embedded
Audio from Router's Input) and 1J (inserted Audio from Output
Boards' 3.5mm stereo Audio jack) and Output whichever is active. If