Owner`s manual
PureLink by Dtrovision
TABLE OF CONTENTS 5
1.2 Product Introduction
The PM series Matrix Router is a Cross-Platform Matrix Router that supports multiple
different digital interface types in a single unit. PureLink's unique "Cross-Platform" feature
makes the Matrix Router most flexible and simple solution for today's sophisticated digital AV
environment.
The PM series Matrix Router supports seven types of digital interface:
HDMI v1.4 (w/optional scaling)
DVI 1.0 (w/optional scaling)
3G/HD-SDI (standard scaling)
Analog VGA/Component
CATx (HDbaseT) (w/optional scaling)
Fiber Optic (w/optional scaling)
Displayport
Each Matrix Router is assembled from field installable I/O (Input/Output) Boards.
The PM-8X Matrix Router can support up to 2 I/O Boards of any of the above type.
The PM-16X Matrix Router can support up to four I/O Boards of any of the above type.
The PM-32X Matrix Router can support up to eight I/O Boards of any of the above type.
The PM-48X Matrix Router can support up to twelve I/O Boards of any of the above type.
The PM-64X Matrix Router can support up to sixteen I/O Boards of any of the above type.
The PM-80X Matrix Router can support up to twenty I/O Boards of any of the above type.
The PM-128X Matrix Router can support up to thirty two I/O Boards of any of the above type.
The PM-256X Matrix Router can support up to sixty four I/O Boards of any of the above type.
The Matrix Router can switch any Input signal to any combination of Outputs. For example,
HDMI Input signal can be Output to 3G/HD-SDI Output, Fiber Optic Output, and CATx Output.
The Matrix Router can route multiple Input/Output configurations simultaneously.
Note) 3G/HD-SDI is not a licensed HDCP interface and if the content received from
HDMI is protected by HDCP, there should be no Output from the 3G/HD-SDI
Board.
PM series CATx I/O Boards are used in conjunction with PM CATx Transmitter and Receiver
and PM series Fiber Optic I/O Boards are used in conjunction with PM Fiber Transmitter and
Receiver.
Note) For I/O Boards and Extenders compatibility information, see page 32