Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 45
recommend to use CATx or Fiber Optic extension system. This will assure future with
higher resolution Video transmission.
 For CATx Input and/or Output Boards, PM CATx Extenders are required. PM CATx
Transmitters pair with PM CATx Input Board and PM CATx Receivers pair with PM CATx
Output Board. See pg. 34 for detail information.
 For Fiber Input and/or Output Boards, PM Fiber Extenders are required. PM Fiber
Extender Transmitters pair with PM Fiber Input Board and PM Fiber Receivers pair with
PM Fiber Output Board. See pg. 35 for detail information.
 Use crossed RS-232/422 cable for serial control
 Use crossed RJ-45 cable for LAN control
Installation and Setup
 Place the Matrix Router into a desired position and screw in the rack ear holes.
* Recommended to screw all 6 holes for secure installation
 Plug power cord into power supply unit on the Matrix Router. For redundancy power use,
plug power cords into both power supply unit
 Connect source devices to the Matrix Router's Input Board using appropriate cables
 Connect display devices to the Matrix Router's Output Board using appropriate cables.
Connect control devices to the Matrix Router's communication ports.
* Command Protocols are communicated through RS-232/422, LAN, or front panel touch
screen. USB connection is only for firmware update.
 Make sure any connected Extenders' power are on.
* CATx Extenders may not need power if they will be powered via POE+
 Turn on the power of display devices
 Turn on the power of Matrix Router
 Turn on the power of source devices
Note) For most of cases, PureLink's Auto EDID factory default setting will result
in a satisfactory image on the display. It's almost plug-n-play system.
There may be cases where additional adjustment is required, please refer
to Auto-EDID management system section pg. 66 or contact PureLink
technical support team for the assistance.