Owner`s manual

FCC/CE Statement
This device complies with part 15 of FCC Rules and EN 55022/55024/61000-3 for CE
certification. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must not accept any interference received,
including interference that may cause undesired operation. This equipment has been tested
and found to comply with the limits for a Class A digital device, pursuant to part 15 and 2 of
FCC Rules and EN 55022/55024/61000-3 for CE certification. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated
in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and. if not installed and used in accordance with the instruction guide, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
 Re-orient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult a service representative for help.
Properly shielded and grounded cables and connectors must be used in order to comply with
FCC/CE emission limits. Changes or modifications not expressly approved by the party
responsible for compliance could void the user s authority to operate the equipment.