Use and Care Manual

2. Auto Humidistat
Press the Auto button to activate the automatic humidity function, then the ideal humidity of
50% is maintained. When the humidity level in the room is less than the auto humidity level
(50%), the humidifier will continue to produce moisture automatically. Once the room level is
met, the humidifier will turn itself off.
3. Timer
Press the Timer button to determine the operating time, it can be regulated between 1 and 12
hours or for continuous operation.
%
4. Adjustable Humidistat
Set the desired humidity in % by pressing the Adjustable Humidistat button. We recommend a
relative humidity of between 40% and 50%. The appliance can be regulated from 40% to 75%
 in5%increments.Ifthehumidityexceedsthedesiredsetting,theappliancewillturnitselfoff.
The appliance will not turn itself off if it has been set for Continuous Operation (“Co”). The
desired value is shown while you are making the selection. After a few seconds, the display
automatically switches to the current value. Note: If the room humidity is below 15% then the
 displaywillash.
DIRECTIONS FOR USE
CONTROL OPERATION
5. Mist Control
When you press the Mist Control button there are three options:
6. Low/No Water
When it is time to refill, the low water indicator will blink on the display.
DIRECTIONS FOR USE
CONTROL OPERATION
Press once for LOW. PresstwiceforMEDIUM. Press three times for HIGH
(no icons will be displayed
for this combination).
E-8 E-9
1. Cool/Warm Mist & Night Light Control
 Turnsnightlighton/off.Selectscoolorwarmmist.Watertemperatureismaintainedatroom
temperature for cool setting and 80 degrees for warm. Allow 15 minutes for water to warm.
 Followinstructionsfordesiredcombination.Theimagesshowthescreen
 displayforthecombinationofthecool/warmmistandnightlightsettings.
Default: Nightlight/Warmmist
control on.
Press 1 time: NightlightOFF.
Warm mist ON.
Press 2 times: Night light ON.
Cool mist ON.
Press 3 times: NightlightOFF.
Cool mist ON.
= Warm
= Night Light
7. Safety Mode “OH”
The humidifier is equipped with a thermal safety device that will display “OH” when activated.
If it enters a mode showing “OH” it will automatically restart when cooled down. If the unit does
not automatically restart, then allow the unit to cool and cycle the power button to reset and
start the humidifier.
Important: If the unit continues to display “OH” or
shut down, there may be an abnormal condition and
the unit may need service. Call Customer Service
at 1-800-603-5900.