Owner`s manual

Installation
Generic Windows drivers
The X2 device does not require any additional driver to operate.
Locate an USB port of your computer and connect, with the cable provided in the
package, the X2 device. The blu led in the front panel of the X2 will light. The first
installation from this point depends from your operating system.
Windows XP and 2000
After the X2 connection the system will display the message “Found new Hardware”
and will install automatically the required drivers.
After this step, the X2 will be ready to use.
Windows Millenium
After the X2 connection the system will display the message “Add new Hardware
Wizard”. Follow the instructions and enable (if asked) the option “Search for the best
driver”. After completing this procedure, the X2 will be ready to use.
Windows 98 SE
After the X2 connection, the system will display the message “Add new Hardware
Wizard”, that will refer to an USB Composite Device (the displayed name could be
different depending on the local and language version of the operating system).
X2 Owner's Manual - Rev. 1.4 - page 6